Installing A New Toilet

by Raul Garcia on August 2, 2011

New toilet installation can be a less expensive process than look for make constant repairs on an old toilet. Installing a whole new toilet is pretty simple and also the project could be finished until the end of your afternoon.  Installing a brand new toilet may require the laying down of pipes incase so, a plumbing contractor should be hired to accomplish the work. 

 Some items are included with the purchasing of a new toilet like washers, some hardware, and gaskets to attach the tank into the bowl. All these parts,  however, are probably not such that you can fully complete the task setting up fresh toilet. Some objects that may ought to be needed are the toilet tank, seat, and bowl, a wax ring, two 1 / 4 bolts for bowl to flange, along with a 20 inch mains water with floor connection. Several tools that are required to the installation are a screw driver, a bucket,  as well as some channel pliers.

 When all parts are assembled the brand new toilet installation can activate. You can find five main steps to keep up with to doing a successful toilet installation.
 
 First, the water into the toilet needs to be shut off. A bucket and cloth should really be utilized to remove any excess water left by the toilet when flushed. Connect bolts inside of a jar
 
 Second, a small pipe wrench or channel pliers ought to be made use to unfasten a nut exactly where the water line is connected into the ballcock valve which is inside the left side of the really of your toilet tank. A smallish crescent wrench should then be applied to your 1/4 inch nuts that connects the bowl to your floor flange. The existing toile can now be removed alongside pool water line.
 
 Third, installing fresh toilet now starts. The a quarter bolts are placed inside the holes of many flange with all the bolt head within the flange.  Old wax ought to be invest this spot. This may stay in this bolts level, both vertically and horizontally. The wax ring will be the placed upon the flange and with the flat side up if it is tapered.
 
 Fourth, to center the bowl, place it straight down at the wax ring so both bolts come through each hold on all sides of your bowl. Area metal washers and nuts on your bolts to tighten them. Over-tightening the bolts could generate the bowl to crack, so caution is needed. Retighten the bolts again after it really is installed thoroughly.
 
 The fifth and final step is putting 2" rubber gaskets at the tank where it is about on the bowl. Put rubber washers around the bolts so they'll be on the lining of many tank. The tank should then be picked up, placed upon the bowl during the holes by the bowl through which the bolts go. Bolts are then connected coming from the throughout the tank into holes within the bowl.  Metal washer and nuts are then put on then should be tightened. Stay in this tank flat and tighten the tank so that it remains like this. A big screw driver should then be taken to tighten the nut below the bowl. Pool water supply should then be linked to your tank. Activate the water,  inspect for leaks, and fasten the bolts that stay in this bowl with the floor.  
 
 The installation of fresh toilet is now completed after completing all five steps. Maintenance of many new toilet need to be executed regularly to avoid any new toilet installation that come from the nearby future.
 

Leave a Comment

Previous post:

Next post: